TC-Helicon VoiceLive 3 - Reference Manual - Manual (Page 82)

The Looper
VoiceLive 3 – Reference manual (2014-03-29) 80
Entering and exiting Loop mode
To enter Loop mode, press and hold the Layer
button. The LED of the Layer footswitch will turn
purple, and the screen will display loop tracks
and other information.
The loop screen shows a combination of con-
trols, which relate to the six footswitches, and
track “thumbnails” that show you what you have
recorded.
To exit Loop mode and return to the previously
active layer (Vocal or Guitar), press and hold the
Layer button.
Loop mode activated
Your first loop
Just to get you started, let’s make a quick loop.
– If you are not already on the Looper layer, go
there now by pressing and holding the Layer
button.
Setting up the metronome
– Let’s turn on the Metronome (MET) so you can
make your loop to a consistent beat.
As you can see, there are six segments in the
display, which correlate to the six footswitch-
es. The lower left segment is labeled “MET”
and represents the HIT footswitch.
– Tap the HIT footswitch.
Metronome settings
The HIT footswitch will begin flashing purple,
indicating that the Metronome is now active.
If you are using headphones, you should hear
a Kick Drum Metronome.
– If you don’t hear a metronome sound over
your headphones:
– Press the Home button.
– Move any of the MIX knobs to access the
Mix page.
– Navigate to the Headphone Mix page using
the Arrow buttons.
– Turn up the Metronome Level.
– Press and hold the Layer button to re-enter
the Looper.