TC-Helicon VoiceLive 3 - Reference Manual - Manual (Page 29)

VoiceLive 3 overview
VoiceLive 3 – Reference manual (2014-03-29) 27
Stereo vocals and a guitar amplifier
This setup is great if you have got a guitar amp
and want to send VoiceLive 3’s guitar sounds to
that amp instead of to the PA.
You may want to make a quick adjustment to the
guitar output if you are connected to an amp.
It might be desirable to turn off VoiceLive 3’s
speaker simulations while preserving all of the
other guitar effects. This will allow the “charac-
ter” of your amp to stay the same from Preset to
Preset.
Follow the Stereo PA connection instructions to
change your output mode to Stereo.
Turning speaker simulation off
– Press Setup.
– Use the < or > Arrow buttons to move to the
Guitar tab.
– Use the Control Knob to move the selection
bar until Speaker Sim Enable is highlighted.
– Turn the Mix Knob directly below the dis-
play until the setting for Speaker Sim Enable
changes from On to Off.
– Press Home to exit.
Turning speaker simulation off
For Mono vocals via the PA and guitar sounds
via a guitar amplifier, follow the diagram above,
but connect only the Left XLR output from Voice-
Live 3 to your PA and set the output mode to
Mono.