TC-Helicon VoiceLive 3 - Reference Manual - Manual (Page 71)

Editing the Guitar layer
VoiceLive 3 – Reference manual (2014-03-29) 69
Drive block / tab
VoiceLive 3’s Drive effect can act as a Boost,
Drive or both.
Essentially, the Drive block has its own set of
PreGain and PostGain parameters, which are in-
dependent from the Amp simulation block. When
Boost is active, these settings replace the cur-
rently active Amp settings, changing your sound.
There are a few preconfigured Drive styles –
make sure you give them a try.
Tips and tricks for working
with the Drive effect
– Since the Amp settings are replaced by the
Boost settings when Boost is active, it’s pos-
sible to make your amp quieter or less distort-
ed when Boost is active.
– You should probably avoid setting PreGain
and PostGain for the Amp and Boost blocks to
wildly different values. You may encounter un-
wanted feedback or drastic volume changes.
Test settings in rehearsal before trying them
out at a gig.
– Boost can be used when playing acoustic gui-
tar, simply to raise the level slightly for a solo
etc.