Juniper Systems Juniper Aspect - Manual (Page 75)

Ch 7 Collecting Data on a Mobile Computer
71
At the top of the map screen on the left, you might see
up to three symbols like the following:
Recent objects used, can use as shortcuts
(symbols for up to the last three are shown).
Mapping a Project
Open the new or existing project you want to map.
Select Menu, then Enable GPS.
You can see the status of the GPS based on the icon
that is shown in the center of the mapping area of the
screen. A green circle indicates that the GPS receiver is
working and that Juniper Aspect is receiving data from
the GPS receiver. A red circle with a “!” symbol indicates
that Juniper Aspect has attempted to activate the GPS
receiver and that you are either in a location where the
GPS cannot acquire a position fix or that the program is
not receiving data from the GPS.
Once the GPS is working and you have a position fix,
select an object to map. Follow these steps.
1. Tap the Objects button near the top of the screen on
the right to open the Object Catalog Selection.