Juniper Systems Juniper Aspect - Manual (Page 115)

Ch 8 Map Functions on a Desktop Computer
111
Adding Valve Coverage
You can add coverage to an irrigation valve that does
not have an existing associated coverage. Either find a
valve that is already mapped or add a new valve. Start
an edit session and select the valve using the Select tool.
When the valve is selected the Add Valve Coverage
icon appears on the ribbon bar. Click on this icon and
begin drawing your valve coverage by clicking on the
map and then drawing the polygon.
Important Note: You must double click to finish the
drawing.
Adding Additional Areas to Existing Valve Coverages
In some cases, you may need to have more than one
area for a valve coverage. An example is when a valve
is watering an area in a median that is divided up into
multiple areas (usually separated by sidewalks or streets).
Start an edit session then select one of the coverage
areas using the Select tool. When just one area is
selected, the Add Area icon appears on the ribbon
bar. Click on this icon and began drawing the added
area by clicking on your map. Double click to finish the
drawing.
Generate Reports
You can use the Generate Report function to see how
your final map will look when you create the report. If you
aren’t happy with it, you can go back to the map and
do more editing. More details on reports are located in
Chapter 9, Generating Reports. Sample maps are shown
at the end of that chapter.