Interlogix DVR 41 User Manual - Manual (Page 123)

11BChapter 12: Network settings
TruVision DVR 41 User Manual 117
To configure RTSP service port:
1. Click the Network Settings icon in the menu toolbar and then click More
Settings .
2. Enter the RSTP port value. The default value 554.
Checking network status
You can easily check network traffic in order to obtain information about the DVR
such as its linking status, MTU, sending/receiving rate, MAC address, and NIC
type.
You can also check the network connection status by testing its delay and packet
loss.
To check network traffic:
1. Click the System Settings icon in the menu toolbar and then click Net detect
to display the Traffic screen. The information displayed is refreshed once a
second.
To check network delay and packet loss:
1. Click the System Settings icon in the menu toolbar and then click Net
detect .
2. Select the Network Detection tab.
3. Under the section “Network delay, Packet loss test”, enter the destination
address and click Test .
The test result appears in a pop-up screen.
4. If you need to check the current network parameters, click the Network
button to get an overview.
To check network statistics:
1. Click the System settings icon in the menu toolbar and then click Net
detect .