Futaba 10C 2.4GHz User Manual
Page 70
70
GOAL of EXAMPLE:
STEPS:
INPUTS:
Set up a FLAP-ELEV mix:
ON
when SWITCH C is in the down
position.
1RHOHYDWRUPRYHPHQWZKHQÀDSVPRYH
up (spoilers),
5% elevator movement when flaps
move down,
LINK
should be ON if model has twin
e l e v a t o r s e r v o s . O t h e r w i s e , LINK
remains OFF.
(Flap has no trim lever, so TRIM is not
an option.)
Open an unused programmable mix.
(Ex: use PROG.MIX3 since it is already
set-up for FLAP-ELEVATOR.)
for 1 second.
(If BASIC,
again.)
C
to PROG.MIX-.
C
to 3 >.
Activate the function.
C
to MIX.
to ON.
Choose master and slave channels.
(Ex: no need to change MASTER/SLAVE.)
already CH6
already CH2
Optional: set Master as OFST or VR(A-E).
See above for details.
C
to MASTER.
to desired choice.
Set LINK and TRIM as needed.
(Ex: leave LINK OFF, TRIM not available.)
Assign SWITCH and position.
(Ex: change from E to C, DOWN.)
C
to SW.
to C.
C
to POSI.
to DOWN.
Optional: set switch to STk-THR to
activate mix with THROTTLE STICK.
(See above for details.)
C
to SW.
to STk-THR.
C
to POSI.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to NULL.
Makes mix active at all times. Not
compatible with STk-THR.
C
to POSI.
to NULL.
Set rates. (Ex: Lo=0%, Hi=5%.)
C
to RATE.
VR(A) past center. Leave at 0%.
VR(A) past center.
to 5%.
Set OFFSET, if needed. (Ex: 0.)
C
to OFFSET. Leave at 0%.
Close menu.
Where next?
Adjust servo END POINTs: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDOD/R,EXP): see p. 42.
Set up additional programmable mixes, ex: RUDDER-AILERON: see p. 68.
View numerous additional mix setups: www.futaba-rc.com\faq\
Other Examples:
• RUD-ELEV (ACRO
GLID) mix: Compensate for pitching up or down when rudder is applied.
• AIL-RUD mix (ACRO): Coordinate turns by applying rudder automatically with aileron input. All model types.
• ELEV-PIT (HELI) mix: compensate for the loss of lift of tilting the model.