beautypg.com

Futaba 10C 2.4GHz User Manual

Page 13

background image

13

NOTE: If you need to remove or replace the transmitter
battery, do not pull on its wires to remove it. Instead,
JHQWO\SXOORQWKHFRQQHFWRUVSODVWLFKRXVLQJZKHUHLW
plugs into the transmitter.

Battery connector location

Charging jack

RF module

Trainer function
/DSC function
connector

Battery cover

NT8S
Ni-Cd battery
pack

Attachment of the Module

CAUTION

Be sure to turn off the power of the transmitter before
you install or replace the module.

To remove, press the tabs together and gently pull
rearwards. To install, line up the connector pins with
the socket in the rear of the module and gently snap
into position.

SWITCH ASSIGNMENT TABLE
• The factory default functions activated by the switches and knobs for a 10CA Mode 2 transmitter are shown below.
• Most 10C functions may be reassigned to non-default positions quickly and easily.
• Basic control assignments of channels 5-10 are quickly adjustable in AUX-CH (see p. 46). For example, the channel 5
servo, which defaults to SWITCH E for retract use, can easily be unassigned (NULL) to allow for easy use as a second
rudder servo in a mix, or to a slider or dial for bomb door or other control.
• Note that most functions need to be activated in the programming to operate.
• 10CA Mode 1, 10CH, and 10CP transmitter functions are similar but reverse certain switch commands. Always check
that you have the desired switch assignment for each function during set up.

Switch/Knob
A or H

Airplane (ACRO)

Sailplane/Glider (GLID)

Helicopter (HELI)

SWITCH A

elevator dual rate
ch10

elevator dual rate
GRZQ EXWWHUÀ\RQ
ch10

elevator dual rate
ch10

SWITCH B

rudder dual rate
ch9

rudder dual rate
ch9

rudder dual rate
ch9

SWITCH C

up = ELE-FLP on
FHQWHUGRZQ IDLE-DOWN
down = AIRBRAKE on

up = ELE-FLP on
center = Distance cond.
down = Landing cond.

governor

SWITCH D

aileron dual rate

aileron dual rate

aileron dual rate

SWITCH E or G*

ODQGLQJJHDUFK

WKURWWOHKROGFK

SWITCH F or H*

VQDSUROOWUDLQHU

trainer

WUDLQHUTHR-CUT

SWITCH G or E*

none

up = Speed cond.
down = Start cond.

idle-up 1 and 2

SWITCH H or F*

none

LGOHXSJ\UR

KNOB A

ÀDSFK
ÀDSWULPLIFLAPERON on)

ÀDS
ch6

HOVERING PITCH

KNOB B

ch 8

ch 8

ch 8

KNOB C

VSRLOHUFK
(disabled if AIL-DIFF on)

ch 7
(disabled if AIL-DIF on)

HOVERING THROTTLE
ch7

SLIDER D

none

ch 5

none

SLIDER E

none

none

HI-PIT

*On the 10CA Mode 2 transmitters, the TOP LEFT SWITCHES are spring-loaded and 2-position; on the 10CA Mode 1, 10CH, and 10CP, those
switches are on the right side. For consistency, the switch position’s designation remains the same (upper left is F, etc), but the functions are moved to
match the switch type.