Futaba 10C 2.4GHz User Manual

Page 109

109

The GV-1 controls throttle when it is active, so the throttle will not obey any FailSafe settings preset for throttle in the
WUDQVPLWWHU$OZD\VVHWWKH)DLO6DIHVHWWLQJIRUWKH*9¶VRQRIIFKDQQHOWR2))7KLVZD\WKHJRYHUQRULVVKXWRII
and the throttle obeys the FailSafe throttle commands.

Expert Tip: Mounting the GV-1 to the counter gear instead of the fan
GUDPDWLFDOO\VLPSOL¿HVLQVWDOODWLRQLQPDQ\PRGHOV

Setting example:

:KHQVSHHGDQG212))DUHXVLQJRQHVZLWFK

Governor Speed

Switch Position

(Switch C or Cond.)

Rate (%)

Adjustment from Tx.

RS1: OFF

or NORM

Use up to 0%.

(Governor speed display reads “off”.)

RS2: 1400

CNTR

or IDL1

Speed adjusted by raising and lowering rate.

RS3: 1700

DOWN

or IDL2

100

Speed adjusted by lowering rate.

*The relationship of the governor speed setting rS1~rS3 and the switch positions conforms to the table above.
*In throttle hold, always check that the governor is off.
*If the speed value rises when the cut switch is activated, reverse the “DIR” setting from UP to DOWN or vice versa.

GOAL of EXAMPLE:

STEPS:

INPUTS:

S e t u p a G V 1 g o v e r n o r t o u s e
b o t h c h a n n e l s i n t o t h e r e c e i v e r
a n d s w i t c h b e t w e e n t h e g o v e r n o r
settings automatically when changing
conditions. Consider setting the battery
Fail Safe settings and other helpful
functions on the GV-1 itself.

O p e n a n d a c t i v a t e t h e GOVERNOR
function.

for 1 second.

(If BASIC,

again.)

to GOVERNOR.

Activate the function.

to MIX.

to ACT.

Optional: change cut-off channel
to channel 8 and assign switch and
direction for on/off (channel 8).

to cut-CH

to +CH8.

t o c u t - S W .

t o d e s i r e d

SWITCH.

Optional: change switch assignment to
select governor settings.
E x : s e l e c t s w i t c h t h a t s e l e c t s t h e
conditions.

to SW.

to Cond.

Adjust governor speed settings per
switch position or condition as needed.
(Ex: defaults are fine.) Allows head
speed adjustment from transmitter.

to each Cond position.

as needed.

to next Cond position. Repeat.

Close the function.

Where next?

GYRO

: see p. 107.

Adjust FailSafe (F/S) settings (p. 50).
$GMXVWLGOHXSFROOHFWLYHSLWFKFXUYHIRUVDPHUDWHVRIFOLPEXSULJKWLQYHUWHG
See p. 101.
$GMXVW HOHYDWRUDLOHURQ UHVSRQVH WR ILW \RXU IO\LQJ VW\OH VHH D/R,EXP and END
POINT

SWASH AFR: p. 42, 39, 95.