Futaba 10C 2.4GHz User Manual
Page 66
66
Throttle delay function THR-DELAY (ACRO):
The THR-DELAY function is used to slow the response of the throttle servo to
simulate the slow response of a turbine engine. A 40% delay setting corresponds
to about a one-second delay, while a 100% delay takes about eight seconds to
respond. For helicopters, see DELAYS, p. 103.
This function may also be used to create a “slowed servo” on a channel other than throttle. This is accomplished by
plugging the desired servo (Ex: gear doors) into CH3 (THR), throttle into an auxiliary channel such as 8, and then using
VRPHFUHDWLYHPL[HV3OHDVHVHHRXU)UHTXHQWO\$VNHG4XHVWLRQVDUHDDWZZZIXWDEDUFFRP?IDT?IRUWKLVVSHFL¿FH[DPSOH
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate THR-DELAY for a ducted-fan
replica of a turbine-powered aircraft.
Slow the servo response byone second.
Open the THR-DELAY function.
for 1 second.
(If BASIC,
again.)
to page 2.
C
to THR-DELAY.
Activate the function.
C
to MIX.
to ACT.
Adjust the RATE to match the desired
servo speed. (Ex: 40%.)
C
to RATE.
to 40%.
Close menu.
Where next?
Set up THROTTLE-NEEDLE mixing: see p. 65.
Adjust throttle’s END POINT: see p. 39.
Adjust throttle exponential (D/R,EXP): see p. 42.
Set up AILEVATOR: see p. 57.
Set up programmable mixes, for example, RUDDER-AILERON: see p. 68.
View additional model setups on the internet: www.futaba-rc.com\faq\
ACRO
only. Optional: increase mixture
w h e n t h ro t t l e i s a p p l i e d r a p i d l y -
ACCE
.(see above for details.)
C
to ACCE.
THROTTLE STICK to idle.
THROTTLE STICK full open
quickly.
as needed.
H E L I
o n l y : s e t c u r v e s f o r o t h e r
conditions.
C
to condition name.
to next condition to edit.
Repeat above steps as needed.
Close menu.