Futaba 10C 2.4GHz User Manual
Page 60
60
GOAL of EXAMPLE:
STEPS:
INPUTS:
A c t i v a t e S N A P - R O L L . A d j u s t
elevatortravel to 55%, rudder travel to
120%
LQ WKH ULJKWXS VQDS $FWLYDWH
SAFE-MOD
so snaps can not be performed
when gear is down.
$GMXVW UXGGHU WUDYHO LQ WKH OHIWGRZQ
snap to 105%.
(Note: using negative percents can
change any of the 4 snap directions. For
example, change snap 1 to "down" by
changing the elevator percent to -100%.)
Open the SNAP-ROLL function.
for 1 second.
(If BASIC,
again.)
C
to SNAP-ROLL.
Activate the function.
C
to MIX.
to OFF or ON.
Adjust the travels as needed. (Ex:
elevator to 55%, rudder to 120%.)
C
to ELEV.
to 55%.
C
to RUDD.
to 120%.
Optional: Activate SAFE-MOD. [Ex: ON
when SWITCH E (10CA) or G (10CH)
is down, meaning snap function is
deactivated when that switch is in the
down position.]
E or G up.
C
to SAFE-MODE
to ON.
snap switch.
Notice MIX reading is still OFF.
E or G down.
Notice MIX reading changes to ON.
Optional: Assign switches to up/down
and left/right. (Ex: Change to the left/
down snap and adjust rudder to 105%.)
C
to SW1.
to A.
C
to SW2.
to B.
A down B down.
Repeat steps above to set percentages.
Close menu.
Where next?
Set up programmable mixes: see p. 61.
View additional setups on the internet:www.futaba-rc.com\faq\.