Futaba 10C 2.4GHz User Manual
Page 62
62
ELEV-FLAP
mixing (ACRO
GLID):
ELEV-FLAP
PL[LQJLVWKH¿UVWSUHSURJUDPPHGPL[ZHOOFRYHU7KLVPL[PDNHV
WKH ÀDSV GURS RU ULVH ZKHQHYHU WKH ELEVATOR STICK is moved. It is most
commonly used to make tighter pylon turns or squarer corners in maneuvers. In
PRVWFDVHVWKHÀDSVGURRSDUHORZHUHGZKHQXSHOHYDWRULVFRPPDQGHG
Adjustability:
• Rate
IXOO XS ÀDS WR IXOO GRZQ ÀDS ZLWK D GHIDXOW RI
RQHKDOIRIWKHÀDSUDQJHLVDFKLHYHG when the ELEVATOR STICK is pulled
to provide full up elevator.)
• Switch: fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up
LOGIC SW
: See p. 38.
*IF you set it to NULL, the mix does not work. (ACRO)
•Range (GLID): The range that mixing does not work near neutral of an elevator
stick can be set up.
Hold the stick to the desired point (upper or lower side) , then press DIAL and
hold one second to set the range.
• Condition (GLID): The separate ELEV-FLAP settings for each condition can be set.
(ACRO)
(GLID)
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate ELEV-FLAP mixing. Adjust flap
travel to 0%
ÀDSVZLWKQHJDWLYHHOHYDWRU
(push) and 45% flaps with positive
elevator.
Open the ELEV-FLAP function.
for 1 second.
(If BASIC,
again.)
C
to ELEV-FLAP.
Activate the function.
C
to MIX.
to ACT.
Adjust the travels as needed.
(Ex: 0%,to 45%.)
C
to RATE.
ELEVATOR STICK.
to 0%.
ELEVATOR STICK.
to 45%.
Close menu.
Where next?
$GMXVWÀDSHURQVÀDSWUDYHODYDLODEOHFLAPERON): see p. 52.
Set up AIRBRAKE
FURZEXWWHUÀ\VHHS
Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 68.
View additional setups on the internet: www.futaba-rc.com\faq\.