Futaba 10C 2.4GHz User Manual

Page 46

Auxiliary channel function (including channel 9-10 controls)(AUX-CH

GH¿QHVWKHUHODWLRQVKLSEHWZHHQWKHWUDQVPLWWHU

controls and the receiver output for channels 5-10. Also, the CH9-10 POSI are used to change the CH9-10 servo direction.
Note that the CH9-10 functions are only visible in the AUX-CH screen when PCM or 2.4H-10CH modulation is selected. The
9-10th channels are not supported in FM modulation. The 8-10th channels are not supported in 2.4G-7CH modulation.

Adjustability:
• channels 5-8 may be assigned to any SWITCH (A-H), LOGIC SWITCH

(Lsw1-Lsw3), slider [VR(D) and VR(E)], or knob [VR(A-C)] (for example,
moving flaps to a switch or slider), but not the primary control sticks (use
programmable mixes to do so, p. 68);

• channel 9-10 may be assigned to any SWITCH (A-H), LOGIC SWITCH

(Lsw1-Lsw3) and the servo direction may be changed.

• multiple channels may be assigned to the same switch, slider or knob;
• channels set to "NULL" are only controlled by mixes. (Ex: utilizing 2 channels

for 2 rudder servos. See mixes, p. 68.)

• If GYRO SENSE, GOVERNOR, and THR-NEEDLE functions are activated, AUX-CH

settings of related channels become invalid automatically.

Related channels:
GYRO SENSE

(ACRO): ch. 5, 7, or 8: see p. 73.

GYRO SENSE

(HELI): ch. 5: see p. 107.

GOVERNOR

(HELI): ch. 7, or ch. 7 and 8: see p. 108.

THR-NEEDLE

(ACRO

HELI): ch. 8: see p. 65.

Remember that if you assign primary control of a channel to a switch which you later use for other functions (like
GXDOWULSOHUDWHVRUDLUEUDNHVHYHU\WLPH\RXXVHWKDWRWKHUIXQFWLRQ\RXZLOODOVREHPRYLQJWKHDX[LOLDU\FKDQQHO

GOAL of EXAMPLE:

STEPS:

INPUTS:

$VVLJQÀDSVWRWKHULJKWVOLGHU>VR(E)]
and set channel 7 to NULL in preparation
to use it as a smoke system control (the
smoke system being activated later by a
throttle-to-ch.-7 mix).

Open BASIC menu, then open AUX-CH
function.

for 1 second.

(If ADVANCE,

again.)

to page 2.

to AUX-CH.

Choose the channel to change. (ex: ch.
6.)

to Ch 7.

Change primary control. (ex: to slider.)

to Vr-E.

Repeat as needed. (ex: ch. 7 to NULL.)

to Ch 7.

to NULL.

Close.

Where next?

Programmable mixes: see p. 68.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDOD/R,EXP): see p. 42.
Adjust SUB-TRIM of auxiliary channel to adjust center SWITCH position:
see p. 49.
Adjust END POINTs (sets end points of travel even when using a switch):
see p. 39.