Futaba 10C 2.4GHz User Manual
Page 64
64
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate AIRBRAKE on a FLAPERON.
model. Adjust the flaperon travel to
75%
,with negative elevator (push) of
25%
.
&RQ¿UPFLAPERON is active.
see FLAPERON instructions.
Open the AIRBRAKE function.
for 1 second.
(If BASIC,
again.)
C
to AIRBRAKE.
Activate the function.
Switch C in up position.
C
to MIX.
to OFF.
Adjust the travels as needed.
(Ex:Ailerons each 75%, Elevator -25%.)
C
to AIL1.
to 75%.
C
to ELEV.
to -25%.
C
to AIL2.
to 75%.
O p t i o n a l : d e l a y h o w q u i c k l y t h e
elevator servo responds.
C
to delay-ELEV.
to 25%.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICK's proximity to
idle.
C
to MODE.
to Linear (0%).
THROTTLE STICK to desired 0
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
Close menu.
Where next?
$GMXVWÀDSHURQVWRWDOÀDSWUDYHODYDLODEOHFLAPERON): see p. 52.
Set up ELEV-FLAP mixing: see p. 62.
Set up programmable mixes, for example, FLAP-ELEVATOR: see p. 67.
View additional model setups on the internet: www.futaba-rc.com\faq\.
• Twin elevator servos:
• If AILEVATOR is active, the AIL1 and AIL2 settings still only affect FLAPERON or AIL-DIFF servos, NOT the elevator servos.
(they would have the AIL3 and AIL4 settings.)