Futaba 10C 2.4GHz User Manual

Page 34

MODEL TYPE

: sets the type of programming used for this model.

The T10C has 15 model memories, which can each support:
•one powered aircraft (ACRO

PHPRU\ W\SH ZLWK PXOWLSOH ZLQJ DQG WDLO FRQ¿JXUDWLRQV 6HH WZLQ DLOHURQ VHUYRV WZLQ

elevator servos, ELEVON, and V-TAIL for further information.);
WKUHHJOLGHUZLQJW\SHVDJDLQZLWKPXOWLSOHWDLOFRQ¿JXUDWLRQV6HH*OLGHUMODEL TYPE for details, p. 78;
•eight helicopter swashplate types, including CCPM. See Helicopter MODEL TYPE for details, p. 93.

%HIRUHGRLQJDQ\WKLQJHOVHWRVHWXS\RXUDLUFUDIW¿UVW\RXPXVWGHFLGHZKLFKMODEL TYPEEHVW¿WVWKLVSDUWLFXODUDLUFUDIW
(Each model memory may be set to a different model type.) If your transmitter is a T10C, the default is ACRO. If it is a
T10C, the default is HELI(H1).

ACRO

is the best choice for most powered airplanes, but in some circumstances, GLID(2A+1F) may be a better choice. ACRO

is usually a better choice because of functions it offers that the GLID types do not:

•ACRO adds:

•SNAP-ROLL
•AILEVATOR (twin elevator servo support)
•For fuel-powered airplanes: IDLE-DOWN, THR-CUT, THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.

•But ACRO lacks:

•5 seperate conditions for optional setups (START

SPEEDDISTANCELANDING)

If you are using a glider or heli MODEL TYPE, please go to that chapter now to select the proper model type and support
your model setup. Note that changing MODEL TYPE resets all data for the model memory, including its name.

GOAL of EXAMPLE:

STEPS:

INPUTS:

Select the proper MODEL TYPE for your
model. Ex: ACRO.

[NOTE: This is one of several functions
that requires confirmation to make a
change. Only critical changes require
additional keystrokes to accept the
change.]

Open the BASIC menu, then open the
PARAMETER

submenu.

Turn on the transmitter.

for 1 second.

(If ADVANCE,

again.)

then

to highlight PARAMETER.

to choose PARAMETER.

Go to MODEL TYPE.

to TYPE.

Select proper MODEL TYPE.
Ex: ACRO.
&RQ¿UPWKHFKDQJH
Close PARAMETER.

to ACROBATIC.

for 1 second.

Are you sure?

displays.

WRFRQ¿UP

to return to BASIC menu.