Futaba 3PJS - Manual (Page 93)

93
SETUP Mode Functions
PCM/PPM Select
This function changes the format of the signals output from the transmitter.
(PPM <-> PCM)
Receiver
When a PCM receiver is used, the transmitter must be set to
PCM. When an FM receiver is used, the transmitter must be
set to PPM.
1. Call the Set-Up mode screen
by pressing the UP and
DOWN keys simultaneously
at the initial screen.
2. Call the PCM/PPM Select
function screen by pressing
the UP or DOWN keys in
function map order.
3. (Mode selection)
Select PCM or PPM by press-
ing the + or - key.
Setting range: PPM, PCM
4. At the end of adjustment,
press the UP and DOWN
keys simultaneously. Or
press the DIRECT key twice.
(The display returns to the ini-
tial screen.)
After the mode is changed, signals are output in the new mode
when the transmitter power is turned off, then back on.
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM