Futaba 3PJS - Manual (Page 55)

55
Select Mode Functions
Idle-Up
Use this function to improve the starting characteristics of the engine by raising the
idling speed when starting the engine of a gas powered car.
Operation
Offsets the throttle neutral position to the forward side or
brake side.
1. Call the idle-up function set-
up screen by pressing the UP
key four times at the initial
screen.
2. Adjust the idle-up rate with
the + or - key.
Setting range: D50~0~U50%
“U”: Forward side, “D”: Brake side
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
3. At the end of adjustment.
press the DOWN key 4 times,
or press the DIRECT key
twice. (The display returns to
the initial screen.)
- 4 times
- 4 times
Setting Amount
The standard value (100% point) of this setting is unrelated to the travel set by the
throttle ATV function. It is 50% of the forward side and brake side total servo throw
from the servo neutral position.
Switch Setting
Select the idle-up function ON/OFF switch with the function select switch function.
(Page 89)
PSH or SLD can be selected.
Operation Display
When this function is activated, the LED flashes.
If the power switch is turned on while the idle-up switch is on, an audible alarm will
be heard. Immediately set the Idle-Up switch to OFF.
Blink
DIRECT ST.EXP M.SEL
UP +
SETUP RESET SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM