Futaba 3PJS - Manual (Page 75)

75
Setup Mode Functions
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
ATL
D/R REV
BT1
COPY
THCV
DSP3
SW1
3CH TH.N PM1
0:30 10.4V
PM2
TILT
RES ALRM
CONTRAST
MOD BFS
F/S
"UP"
"DOWN"
"UP" "DOWN"
Setup Mode Functions
The functions in the Set-Up mode are made up of
functions that are not changed after basic setting
and functions that are not changed very much after
being set. To prevent accidental changing of the
settings, this menu is separate from those of the
other modes.
Key layout
Function Map
Set-Up mode functions
- Dual rate . . . Page 76
- ATL . . . Page 78
- Channel 3 position . . . Page 79
- Throttle neutral . . . Page 80
- Programmable mixing 1/2 . . . Page 81
- Tilt mixing . . . Page 85
- Servo reverse/Function reverse . . . Page 87
- Function selection trim . . . Page 88
- Function selection switch . . . Page 89
- Fail safe . . . Page 91
- Battery fail safe . . . Page 92
- PCM/PPM selection . . . Page 93
- LCD contrast . . . Page 94
- Audible alarm tone . . . Page 95
- Model reset . . . Page 96
- Model copy . . . Page 97
- Throttle curve selection . . . Page 98
- Rate display selection . . . Page 99
Channel 3
position
When the UP and DOWN keys are pressed simulta-
neously at the initial screen, the setup mode is se-
lected.
Thereafter, the set-up screen can be sequentially
called with the UP or DOWN key.
Throttle
neutral
Programming 1 Programming 2
Tilt mixing
(Initial screen) Dual rate
Servo reverse/
Function reverse
Rate display
selection Function
selection trim
Throttle curve
selection
Function
selection switch
Model copy Fail safe
Model reset
Audible
alarm tone
LCD contrast PCM/PPM
selection
Battery
fail safe
DOWN
UP
ATL