Futaba 3PJS - Manual (Page 42)

42
Direct Mode Functions
(CRV curve)
The CRV curve can be set for the forward side only. The brake side is set with the
EXP curve.
1) Select the point (P1~P5) of
the trigger you want to set
with the SELECT key.
Setting range; 0~100%
- Return to the initial value by pressing the + and - keys simulta-
neously for about one second.
- When you want to return the entire curve to the initial
value, display RES on the screen by pressing the
SELECT key, then press the + and - keys simulta-
neously.
- Pressing the SELECT key switches to
the points P1 to P5 set-up screens.
Point No. display (P1~P5)
Point position display
The trigger position to which the currently set
point corresponds blinks.
Trigger position display
When the throttle trigger is operated, its po-
sition is displayed. Correspond it with the
point position display above.
Throttle curve
Initial value
(normal curve)
Set value
Trigger point
- The graph form shown on
page 111 is convenient when
setting the throttle curve.
Example
Initial values
P1 : 16%
P2 : 33%
P3 : 50%
P4 : 67%
P5 : 83%
DIRECT ST.EXP M.SEL UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
2) Set the value of the selected
point with the + and - keys.
Adjust each point by repeating
steps 1) and 2).
- Neutral point 0% and high point 100% are
fixed and cannot be changed.
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM