Futaba 3PJS - Manual (Page 56)

56
Select Mode Functions
Throttle Acceleration
Gas powered cars require a slight clearance in the linkage. Therefore, there is a lag
time at both the forward and brake sides. The response of an electric car is obtained
by reducing this time lag at the transmitter.
Carburetor
Servo horn
Brake side
Operation
- Sharply increases the throttle response near the throttle
trigger neutral position.
- The forward side and brake side can be adjusted indepen-
dently.
1. (Forward side setting)
Call the throttle acceleration
function set-up screen by
pressing the UP key five
times at the initial screen.
2. Adjust the forward side with
the + or - key.
Setting range: 0~100%
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
3. (Back side setting)
Call the back side set-up
screen by pressing the SE-
LECT key once.
4. Adjust the back side with the
+ or - key.
Setting range: 0~100%
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
- 5 times
Blink
Blink
A slight clearance is required at the linkage, but the
throttle acceleration function acts to reduce the time
lag caused by this clearance.
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM