Set-up procedure when installed in a car) – Futaba 3PJS User Manual

Page 31

Text mode
Original mode

Initial Set-Up

(Set-Up Procedure When Installed In a Car)

When installing the servos in a car, performing function set-up in the following order
is recommended.

1. Perform step 3. Trims Initial Set-Up of Preparations on the

preceding page.

2. Set the servo direction of operation using the Reverse

function. (Page 87)

The servo installation method and linkage direction depends
on the kit. Therefore, the servo operation direction may have
to be reversed relative to transmitter operation. Before in-
stalling the servo, check the operating direction and set it us-
ing the Reverse function.

3. Set the subtrim and adjust the servo neutral point. (Page

47)

4. Set the trigger travel by adjusting the throttle trigger me-

chanical ATL to you liking. (Page 17)

5. Set ATV of each channel and adjust the servo throw

(travel). (Pages 33~ 38)