Futaba 3PJS - Manual (Page 17)

17
Before Using
Mechanical ATL Adjustment
Adjustment
Using a Phillips screwdriver, adjust the trigger
brake (back) side stroke by turning the screw
through the adjusting hole indicated by the ar-
row in the figure. (The screw moves the
throttle trigger stopper.)
- When the adjusting screw is turned clockwise, the
stroke becomes narrower.
Make this adjustment when you want to make the throttle trigger brake (back) side
stroke
narrower.
Wheel Tension Adjustment
Make this adjustment when you want to change the steering wheel spring tension.
Adjustment
Turn the screw inside the adjusting
hole using a 1.5mm hex wrench.
Caution
If turned too far counterclockwise, the adjusting screw may fall out.
Tension adjusting
screw
- Turning the adjusting screw
clockwise, increases the spring
tension.
Mechanical ATL
adjusting screw
SETUP
DOWN SELECT
ATV TH.EXP
RESET
-
CUSTOM
DIRECT
SELECT
TH.EXP
Caution
When the stroke was adjusted, the throttle servo travel must be adjusted by data set-
ting.