Futaba 3PJS - Manual (Page 24)

24
Before Using
SET-UP Mode Function Selection
To call the function set-up screen in the SET-UP
mode, press the UP and DOWN keys simulta-
neously.
After that, select the function with the UP or DOWN
key.
To end the SET-UP mode, press the UP and DOWN
keys simultaneously again, or press the DIRECT key
twice.
SELECT Mode Function Selection
To call the function set-up screen in the SELECT
mode, press the UP or DOWN key at the initial
screen.
After that, select the function with the UP or down
KEY.
To end the SELECT mode, return to the initial
screen by pressing the UP or DOWN key similarly,
or press the DIRECT key twice.
Edit keys
DIRECT Mode Function Selection
To call the function set-up screen in the DIRECT
mode, first press the DIRECT key, then select the
function by pressing the key corresponding to the
function desired as shown below.
- Steering EXP key (ST.EXP)
- Model select key (M.SEL)
- Throttle EXP key (TH.EXP)
-ATV key (ATV)
- Custom key (CUSTOM)
To end the DIRECT mode, press the DIRECT key
twice.
Data Entry Keys
Use the SELECT key to select the set-up item and
channel at the function set-up screen.
Use the + and - keys to enter data. To reset (return to
initial value) the entered data, press the + and - keys
simultaneously.
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
Switch screen display
For functions that can use the push-button switch (PSH) or slide switch (SLD), the
following symbols are displayed on the setup screen of the relavent function.
(A.B.S. function example)
*For the A.B.S function, both switches can be set.
[If this is displayed, SLD can be set]
[If this is displayed, PSH can be set]
When the screen switch display is enlarged as
shown at the right, that switch can be set.
[Display is enlarged]