EVCO c-pro nano HPR0 - Manual (Page 16)

C-PRO NANO HPR0 APPLICATION MANUAL
Page 16
3.5 Main ON page
The main page displays the temperature of the outlet water and the relative icons on at that moment.
By pressing the DOWN key for about 2 seconds from this page, enter MENU.
From MENU, by pressing the ESC key, go back to the main page.
3.6 Main Menu
The main menu does not have a level and is the access point for all other system menus.
USEr (USER Menu)
MAin (MAINTENANCE-INSTALLER menu)
CoSt (MANUFACTURER menu)
StAt (MACHINE STATUS menu)
From this page, select which menu to enter using the UP and DOWN keys and press the ENTER
key to confirm.
By pressing ESC from this menu, go back to the initial page.
3.7 StAt menu
If StAt is selected from the main menu, some main system states are displayed:
Unit : indicates the state in which the machine is operating ( OFF , ChIL, pdC )
CMP1: state of compressor 1 ( OFF , tOn , On , tOFF )
CMP2 : state of compressor 2 ( OFF , tOn , On , tOFF )
PMP1 : state of the outlet circuit pump ( OFF , tOn , On , tOFF )
PMP2 : state of the geothermic circuit pump ( OFF , tOn , On , tOFF )
fLw1 : state of the outlet circuit flow switch ( OFF, tOn , On , ALAr )
fLw2 : state of the geothermic circuit flow switch ( OFF, tOn , On , tAL, ALAr )
By pressing ENTER on the label, see the value of the relative state, by pressing ESC go back to the
main menu mask. This menu is not protected by a password.
3.8 User Menu
The user level password or higher must be entered in order to display/modify the parameters present
in this branch.
SPC1 (summer - cooling setpoint)
SPH1 (winter - heating setpoint)
SSC1 (summer setpoint offset)
SSH1 (winter setpoint offset)
PSd1 (USER password)