EVCO EVXV815P7 Installer manual - Manual (Page 30)

EVCO S.p.A. EVXV 800 range | Installer manual ver. 1.2 | Code 144XV800E124
page 30 of 66
Inf. Meaning
8.0 the critical value is 8.0 °C/8 °F
StA the display is about to show the date and time the alarm occurred
y11 the alarm occurred in 2011 (continue...)
n03 the alarm occurred in in the month of March (continue...)
d26 the alarm occurred on 26 March 2011
h16 the alarm occurred at 16:00 (continue...)
n30 the alarm occurred at 16:30
dur the display is about to show the duration of the alarm
h01 the alarm had duration of 1 h (continue ...)
n15 the alarm had duration of 1 h and 15 minutes
AH3 the alarm code selected
The displays each piece of information for 1 s.
Operate as follows to abandon the succession of information:
7. Press and release the START/STOP key: the display will show the alarm code selected again.
Operate as follows to exit the procedure:
8. Abandon the succession of information.
9. Press and release the UP or DOWN key until the display shows the magnitude indicated in paragraph 5.3 "The
display" or do not operate for 60 s.
7.3 Deleting the information relative to the HACCP
alarms
Operate as follows:
1. Make sure that the keyboard is not locked and that no procedure is in progress.
2. Hold the DOWN key down for 1 s: the display will show the first label available.
3. Press and release the UP or DOWN key to select “rLS”.
4. Press and release the BLAST CHILLING key: the display will show “0”
5. Press and release the UP or DOWN key within 15 s to set “149”.
6. Press and release the BLAST CHILLING key or do not operate for 15 s: the display will show “- - - -” flashing for
4 s and the HACCP LED will switch off, after which the device will automatically exit the procedure and the
display will show the magnitude indicated in paragraph 5.3 “The display”.
If the device has not memorised any information relative to the HACCP alarms, the “rLS“ label will not be displayed.