Comtrol ES7528 - Manual (Page 177)

RocketLinx ES7528 User Guide: 2000509 Rev. C VLAN (CLI) - 177
Configuration Using the Command Line Interface (CLI)
VLAN Configuration (continued)
Display – VLAN
table
Switch# sh vlan
VLAN Name Status Trunk Ports Access Ports
---- ---- ------ ------------ --------------------------
1 VLAN1 Static - fa1-7,gi25-28
2 VLAN2 Unused - -
3 test Static fa 4 -7,gi25-28 fa1-3,fa7,gi25-28
Display – VLAN
interface
information
Switch# show interface vlan1
interface vlan1 is up, line protocol detection is disabled
index 14 metric 1 mtu 1500
HWaddr: 00:c0:4e:ff:01:b0
inet 192.168.250.100/24 broadcast 192.168.250.255
input packets 639, bytes 38248, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0,
missed 0
output packets 959, bytes 829280, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0,
window 0
collisions 0
GVRP Configuration
GVRP enable/
disable
Switch(config)# gvrp mode
disable Disable GVRP feature globally on the switch
enable Enable GVRP feature globally on the switch
Switch(config)# gvrp mode enable
Gvrp is enabled on the switch!
Configure GVRP
timer
Join timer /Leave
timer/ LeaveAll
timer
Switch(config)# inter fa1
Switch(config-if)# garp timer
<10-10000>
Switch(config-if)# garp timer 20 60 1000
Note: The unit of this timer is centiseconds.
Management VLAN
Management VLAN
Switch(config)# int vlan 1 (Go to management VLAN)
Switch(config-if)# no shutdown
Display
Switch# show running-config
….
!
interface vlan1
ip address 192.168.250.17/24
ip igmp
no shutdown
!
….