Comtrol ES7528 User Manual
Page 159
RocketLinx ES7528 User Guide: 2000509 Rev. C
Port Configuration (CLI) - 159
Configuration Using the Command Line Interface (CLI)
Rate Control
Rate Control
– Ingress or
Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Rate Control
– Filter
Packet Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control
– Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-100> Limit in megabits per second (0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Storm Control
Storm
Control –
Packet Type
Switch(config-if)# storm-control
broadcast :Broadcast packets
dlf :Destination Lookup Failure
multicast :Multicast packets
Storm
Control -
Rate
Switch(config)# storm-control broadcast
<0-100000> Rate limit value 0~262143 packet/sec
Switch(config)# storm-control broadcast 10000
limit_rate = 10000 packets/sec
Set rate limit for Broadcast packets.
Switch(config)# storm-control multicast 10000
limit_rate = 10000 packets/sec
Set rate limit for Multicast packets.
Switch(config)# storm-control dlf 10000
limit_rate = 10000 packets/sec
Set rate limit for Destination Lookup Failure packets.
Port Trunking
LACP
Switch(config)# lacp group 1 25-28
Group 1 based on LACP(IEEE
802.3ad) is enabled!
Note: The interface list is gi25-28. Ports with a different speeds cannot be aggregated together.
Static Trunk
Switch(config)# trunk group 2 fa6-7gi25-28
Trunk group 2 enable ok!