Kenwood TM-261A - Manual (Page 58)

jProiiaMe Cam CoifB^hte Asifon
Page
m.
Memory channels cannot
be selected by turning the
Tuning control or by
pressing microphone
[UP]/IDWN] when using
Memory Recall.
1 No data has been saved in any
memory channels, or entered data
was erased by a Full Reset.
2 The Cali channel is selected.
1 Store data in some memory channels.
2 Press [MR] to switch to Memory Recall.
25
26
You cannot transmit even
though you press [PTT].
1 The microphone plug is not
inserted completely in the Front
Panel connector.
1 Switch OFF the power, ensure the
microphone connector on the Front Panel
has no foreign objects in it, then insert the
microphone plug until the locking tab clicks
in place.
6
2 You have selected a transmit offset
that places the transmit frequency
outside the transmit band range.
2 Press [F], [SHIFT] one or two times so
neither “+ “ nor are visible.
22
Packet operation results in
no connects with other
stations. 1 Your frequency differs from the
target station’s frequency.
1 Adjust your frequency using the Tuning
control.
49
2 The modulation level from the TNC
is incorrect.
2 Adjust the TNC modulation level according
to the TNC instruction manual.
49
3 There is multi-path distortion. 3 Reorient or relocate the antenna. The
strongest signal does not always provide
the best operation on packet.
49
4 The TX delay time parameter in
your TNC is set incorrectly.
4 Set the TX delay time to more than
300 ms.
49
131
52