Fixed station operation – Kenwood TM-261A User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fixed Station Operation
In order to use this transceiver for fixed station
operation, you will need a separate 13.8 V DC power
supply that must be purchased separately.
The following table lists the current capacity
recommended for power supplies used with each type
of transceiver.
Tnmss8imMod«l
Power Supply Ca|mc%
TM-261A
11 A or more
TM-261 EJ
4 A or more
TM-461A
10 A or more
1
Connect the DC power cable to the regulated DC
power supply and check that polarities are correct
(Red: positive, Black: negative).
•
DO NOT directly connect the transceiver to an AC
outlet!
•
Use the supplied DC power cable to connect the
transceiver to a regulated power supply,
•
Do not substitute a cable with smaller gauge wires.
2
Connect the transceiver’s DC power connector to
the connector on the DC power cable.
• Press the connectors firmly together until the locking
tab clicks.
Note:
For your trartsceiver to fully exhibit its performance capabilities,
the following optional power supply is recommended:
PS-33 (20.5 A, 25% duty cycle).
Before connecting the DC power supply to the transceiver, be
sure to svwtch the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you
make ail connections.