Kenwood TM-261A - Manual (Page 11)

Replacing Fuses
If the fuse blows, determine the cause then correct the
problem. After the problem is resolved, then replace the
fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your dealer or
nearest Service Center for assistance.
Rise Local^'efl Rise Currsiif Rating
TM-261A 15 A
TM-261EJ 4 A
TM-461A 10 A
Supplied Accessory
DC Power Cable
20 A
CAUTION: Only use fuses of the specified type and rating.
Note: If you use the transceiver for a long period when the vehicle
battery is not fully charged, or when the engine is OFF, the battery
may become discharged, and will not have sufficient reserves to start
the veNcle. Avoid using the transceiver under these conditions.
ANTENNA CONNECTION
Before operating, you must first install an efficient,
well-tuned antenna. The success of your installation will
depend largely on the type of antenna and its correct
installation. The transceiver can give excellent results if the
antenna system and its installation is given careful
attention.
Your choice of antenna should have a 50 impedance to
match the transceiver input impedance. Use low-loss
coaxial feed line that also has a characteristic impedance of
50 Q. Coupling the antenna to the transceiver via feed
lines having an impedance other than 50 Q reduces the
efficiency of the antenna system, and can cause
interference to nearby broadcast television receivers, radio
receivers, and other electronic equipment.
CAUTION:
♦ Transmitting without first connecting an antenna or other matched
toad may damage the transceiver. Always connect the antenna to
the transceiver before transmitting.
♦
Alt fixed stations should be equipped with a lightning arrester to
reduce ti^e risk of fire, electric shock, and transceiver damage.
connector connector