Simplex memory channels, Split memory channeis, 4 press [mr] (1 s) – Kenwood TM-261A User Manual
Page 31: Split memory channels, Hi m, L u u u
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Simplex Memory Channels
1
Select the desired frequency and associated data
(Tone, CTCSS, DTSS, etc.) using VFO mode,
Memory Recall {page 26}, or the Call channel
{page 27).
2
Press
[F]
to enter Function Select mode.
• “P and a memory channel number appear.
I u u o Hi m
f t L U u u
LOCK
-5 --- 7-
loFF
OVER
DTSS
SHIFT
3 Turn the
Tuning
control, or press microphone
[UP]/[DWN],
to select the desired memory channel.
4
Press
[MR].
•
The selected frequency and associated data are
stored in the memory channel, A transmit frequency
from a split memory channel or split Call channel is not
stored.
•
If the memory channel selected in the previous step
already contained data, the new data ovenrtrrites the
previous data.
•
The previous mode is restored.
Note: After completing each of Steps 2 and 3, you must execute the
next step within approximately 10 seconds or the previous mode is
restored.
Split Memory Channeis
1
Select the desired receive frequency, and associated
data (Tone, CTCSS, DTSS, etc.) using VFO mode,
Memory Recall (page 26} or the Call channel
{page 27}.
2
Press
EF]
to enter Function Select mode.
•
“P and a memory channel number appear.
3
Turn the
Tuning
control, or press microphone
[UP]/[DWN],
to select the desired memory channel.
4
Press
[MR] (1 s).
•
“ - + ” appears.
\
t V
j
u
o
Hi m
( f
L u u u
MHz
TONE
REV
• The channel number is visible if using Memory Recall
mode and the Call channel “C” is visible if using Call
channel mode in Step 1.
Turn the
Tuning
control, or press microphone
[UP]/[DWN],
to select the desired transmit
frequency.
25