Kenwood TM-261A - Manual (Page 53)

CONFIGURING PROGRAM FUNCTION KEYS
The Programmable Function keys are [PF], [MR], and
[VFO] located on the face of the microphone. If you prefer,
you can change the default functions assigned to these
keys.
Pi 09 iaimna&}« Funi^iion Key DefauK FuftcKon
[PF] MHz Select
[MR] Memory Recall
[VFO]
VFO Select
Press one of the following key combinations depending
on which key you want to re-assign:
Microphone [PF\+ POWER ON (“PF1" appears)
Microphone [MR]+ POWER ON (“PF2” appears)
Microphone [VFO]+ POWER ON (“PF3" appears)
Press the key or key combination on the Front Panel
that you want to assign to the Programmable Function
key pressed in Step 1.
• The following types of Front Panel key functions can be
assigned:
[KEY]
[KEY](1 s)
[F],
[KEY]
• The following types of Front Panel key functions cannot be
assigned;
[KEY]+ POWER ON
[F]
[F](1s)
POWER switch
Tuning control
VOL control
SQL control
• After assigning a function that is executed by pressing
[KEY] (1 s), press the configured Program Function key
for 1 second or longer to execute the function.
• The Front Pane! key will still function normally after
“copying” its function to a Programmable Function key.
• To restore the default functions shown in the table, do a
Full Reset {page 29}.
Note:
♦ U the LOCK switch located on the rear of the microphone is ON, you
cannot re-assign the Programmable Function keys.
♦ If microphone [PF] is assigned Monitor or Enter by accessing “PF’ in
Menu B {page 17}, you cannot re-assign microphone [PF] by
pressing microphone [PF]+ POWER ON.
[11
47