Kenwood TM-261A - Manual (Page 13)

GETTING ACQUAINTED
The following sections describe basic functions of the Front
Panel controls and buttons, Rear Pane! jacks and
connectors, microphone buttons and Display indicators.
For full explanations of functions mentioned, refer to the
appropriate sections elsewhere in the manual.
FRONT PANEL
The labels for some of the Front Panel buttons appear on
the Display instead of on the panel or buttons. The
displayed button labels change depending on which mode
the transceiver is in. This “GETTING ACQUAINTED”
section refers to the buttons that do not have labels on the
Front Panel by the labels that appear on the Display
immediately after switching ON the transceiver.
© VFO button
Selects the VFO mode {page 15}. The Tuning control
changes the transceiver frequency in this mode. Also
provides:
• Menu A or Menu B selection of choices (page 17}.
• VFO Scan start/stop to scan the entire VFO range {page 32}.
• Program Scan start/stop to scan a programmed range of
frequencies (page 34}.
© MR button
Selects the Memory Recall mode {page 26}. The Tuning
control changes the memory channel in this mode. Also
provides:
• Memory Scan start/stop {page 32}.
© Tuning control
Selects transmit/receive frequencies while in VFO mode
and memory channels while in Memory Recall mode
(pages 15, 26}. Also provides:
• Menu A or Menu B selection of function or choices (page 17].
• Program Scan limits select to choose the boundaries for this
type of scan (page 34},
• Scan direction select to choose if Scan progresses upward or
downward in frequency {pages 32, 35}.
• DTSS code select {page 37},