Kenwood TM-261A - Manual (Page 40)

PROGRAM SCAN
This type of scan is similar to VFO Scan except the
programmable aspect allows you to set scan limits to limit
the frequency range of the scan.
■ Setting Scan Limits
1 Press [F]+ POWER ON to access Menu B.
2 Select “PGM.SCN” {page 17}.
3 Press [VFO],
• “LO" and the current lower limit appears. The default
is the currently selected frequency.
MENU,
I U C O C “
I I I _____ f
MHz
---- >------- OVER
TONE REV
Turn the Tuning control, or press microphone
[UP]/[DWN], to display the desired lower limit.
• Press [MHz] if you want to change the frequency in
1 MHz steps.
Press [VFO].
• “UP" and the current upper limit appears. The default
is the currently selected frequency.
6 Turn the Tuning control, or press microphone
[UP]/[DWN], to display the desired upper limit.
• Press [MHz] if you want to change the frequency in
1 MHz steps.
7 Press [VFO] to set the upper limit.
8 Press [F] or microphone [PTT] to exit Menu B.
Note:
♦ The lower limit must be lower in frequency than the upper limit.
♦ The lower and upper frequency steps must be equal.
♦ Selections must be made within approximately 10 seconds or the
previous mode is restored.
Confirming Scan Limits
1 Press [F]+ POWER ON to access Menu B.
2 Select “PGM.SCN” (page 17).
3 Press [VFO].
• This is the lower limit.
4 Press [VFO] again.
• This is the upper limit.
5 Press [F] or microphone [PTT] to exit Menu B.
34