U. u u. u u u – Kenwood TM-261A User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FLOW CHART FOR REPEATER ACCESS
\7
Select an offset frequency.
<7
Select an offset direction.
Activate theTone function, if necessary.
<>
Select a Tone frequency, If necessary.
O
Select how much the transmit frequency will be offset
from the receive frequency.
Selecting Offset Frequency
1
2
Press
[F] (1 s)
to access Menu A.
Select “O.S” {page 17}.
• The current offset frequency appears.
MENU rt
n
r m o Hi n
u. u u. u u u
MHz
TONE
REV
3 Select the appropriate offset frequency within
20 MHz of the receive frequency.
•
The setting for “FS" (Menu A) determines the
frequency steps used while you are selecting the
offset frequency.
•
The minimum selectable offset frequency is dependent
on the current frequency step.
4
Press
[F]
or microphone
[PTT]
to exit Menu A.
Note: Selections must be made within approximately 10 seconds or
the previous mode is restored.
21