Kenwood TM-261A - Manual (Page 54)

D
Programming Microphone [PF]
You can program microphone [PF] with a function that
cannot be activated using the Front Panel keys.
Access “PF” in Menu B to select USeR setting,
MONitor, or ENTer {page 17}. The default is USeR
setting.
When you select USeR setting;
The function assigned by pressing [PF]+ POWER ON is
selected (Default: MHz)
When you select MONitor:
You can monitor activity on the current frequency.
Pressing microphone
[PF] toggles the function ON and
OFF. Scan will not function if Monitor is ON (squeloh
open).
When you select ENTer:
After pressing microphone [PF], you can enter digits
from the MC-53DM microphone. Refer to “KEYPAD
DIRECT ENTRY” (page 43}.
SWITCHING AM/FM MODE
(SOME TM-261A VERSIONS ONLY)
Some versions of the transceiver are able to receive AM
and FM modes. The AM mode is selected automatically
when any frequency in the range 118.000 to 135.995 MHz
(AIR band) is chosen. Outside this range, the default is
FM. However, either mode can be selected manually on
any VHF frequency. Crossing the 136.000 MHz boundary
restores the default modes.
Press [MHz] (1 s) to toggle between FM and AM.
• When AM is selected, a spade icon appears.
/
u u Hi nt m
i f uu u u
MHz
V___
- 7 -------« — OVER
TONE REV
48