To set the fabric in the embroidery hoop – Kenmore 200 User Manual

Page 64

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To Set the Fabric in the Embroidery Hoop

Q] Mark the reference lines (3) on the right side of the fabric

where you wish to sew the design as illustrated using
tailor’s chalk.

(3) Reference lines

[U Place the template on the fabric by matching the

reference lines on the template to the reference lines you
previously marked on the fabric.

Tape the template

to the fabric as shown to hold the

template in place. {Transparent tape is recommended.)

0 Tape
0 Template

[U Place the fabric with the template attached to it over the

outer hoop © and push the inner hoop ® into the outer
hoop @.
• Push the flat side of the inner hoop ® into the flat side

of the outer hoop @.

• While squeezing the knob ® together, push the round

part of the inner hoop into the round part of the outer
hoop so the material is secure.

spots)

® Sewing area

H Remove the template by putting your finger in the thumb

hole ® located on the template and lift up.

(Q) The hole for removing the template

This manual is related to the following products: