Inserting the bobbin – Kenmore 200 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Inserting the bobbin
(T) End of thread
(D Notch
(3) Notch
(4) Threading diagram
D
Piace a bobbin in the bobbin holder with the thread
running off counterclockwise.
I Guide the thread into the notch
(2)
on the front side of
the bobbin holder.
Draw the thread to the left, sliding it between the tension
spring biades.
S]
Continue to draw the thread lightly until the thread slips
into notch (3). Pull out about 6" (15.0 cm) of thread.
I Attach the hook cover plate. Check the threading by
referring to the diagram
(¡)
shown on the hook cover plate.
15