ALTANA Haze-Gard Dual - Manual (Page 54)

53
English
"#
#(%)$)*%
*!-'&(*
,
)'
Error messages during
calibration (ISO and ASTM):
If errors occur during calibration, the
device evaluates the measurement
process as an error and requests
the following corrections, depending
on the procedure involved:
Cause
During calibration to a different
transmission standard (ASTM only),
the value was incorrectly entered or
an attempt was made to calibrate
using the incorrect standard.
Remedy
Enter the correct value or use the
correct standard.
Cause
The haze-port was not covered
during dark measurement.
Remedy
Cover the haze-port.
Cause
The cover or specimen were not
removed for light measurement
Remedy
Remove cover or specimen.
#"(*"&%
(&#"(*"&%
#)&+(
-'&(*
,
)'
#"(*"&%
#"(*"&%
#)($&+&+(
(&$!-'&(*
,
16 Error Messages