ALTANA Haze-Gard Dual - Manual (Page 12)

11
English
3.2 Setting the Equipment Up
Always switch off the device
before plugging in or unplugging
the various connectors (foot
switch, printer cable, and power
cable)!
To ensure that the measurement
device is being used correctly
and safely, check that the voltage
setting is correct!
• Unpack the device and check for
possible damage sustained during
shipment (visual inspection).
• Before starting the device for the
first time, check that all
components have been delivered
(for a list of package contents, see
Chapter 15 Ordering Guide).
• Set the voltage selector on the
instrument and, if necessary,
change it to the correct setting as
follows: use an appropriate tool
(No. 2 screwdriver) to remove the
fuse insert below the power-cable
receptacle and plug the insert
back in so that the mark on the
power-switch coincides with the
required voltage range.
• Plug the enclosed power cord into
the device and into a grounded
power outlet.
• If applicable, plug the foot switch
and printer or PC connection into
the appropriate slots.
3 Startup