ALTANA Micro-Wave-Scan Manual - Manual (Page 36)

35
9.1 Number of Measurements
This function allows selection of the numbers of
readings to be taken per sample. If the number is
greater than 1, the measurements are statistically
evaluated. Turning the scroll wheel adjusts the
number while pressing it shifts the decimal place
one further over. Pressing operate completes the
process and a confirmation display appears.
9.2 Scanlength
The setting options for Scanlength are shown in
the neighboring illustration. The current setting is
identified by a black dot at the end of the line.
Move the cursor to the desired setting and press
the operate button. The instrument returns to the
previous menu.
In the setting 0 cm, you can perform
measurements without scan motion. However, you
can only determine the scales du, Wa, Wb and
DOI here.
Note:
Using a short scanlength will result in strong
statistical skewing of measurement values for large
wavelengths. Thus, when using the Wd scale with
a scanlength of 5 cm, at least 3 measurements
should be made per checkzone to ensure
representative values.
Configuration
Scanlength
0 cm
5 cm
10 cm
20 cm
l