ALTANA Micro-Wave-Scan Manual - Manual (Page 22)

21
5.2 Display of measurement results
The measurement results displayed will vary
depending on the options selected in the
Configuration (see chapter 9, 10). Displayed
results may be broken down into the following
elements:
A: Name of the measured sample or checkzone.
B: The number of performed and predefined
measurements (e.g. 2 of 3).
The statistic function is activate if the predefined
number of measurements is greater than 1.
C: If the statistic function is activated, the selected
statistical values appear here.
The measurement values appear in the lower part
of the display area.
Pressing the operate button now, the values will
disappear and the number of readings is increased
by one. Or, if a sample is finished, the name of the
next checkzone/sample will be displayed.
To exit the measurements, press the scroll wheel.
A menu for deleting, interrupt or ending the series
appears. Use the scroll wheel to move the cursor
to “End Test Series” and press operate. The
display switches to the Measure menu after a
request for confirmation.
Getting started
Measure
End Test Series
Delete Last
Delete Checkzone
Delete Testserie
Inter. Checkzone
Parameter Info
*