11.3. command command command command – A&D Weighing ML-50 User Manual
Page 54
MS-70 / MX-50 / MF-50 / ML-50
52
In Case of Format included Temperature Data (Function Table
In Case of Format included Temperature Data (Function Table
In Case of Format included Temperature Data (Function Table
In Case of Format included Temperature Data (Function Table 5555----d 1
d 1
d 1
d 1
) ) ) )
The first 3 figures are the temperature data.
The format consists of nineteen characters except the terminator.
In case of the MS-70
In case of the MX-50 or MF-50
In case of the ML-50
11.3.
11.3.
11.3.
11.3. Command
Command
Command
Command
The analyzer can be controlled by the following commands from the computer.
Add
a
terminator ( 0Dh 0Ah ) to each command.
Command Description
Q
Outputs the current data.
SIR Outputs
data
continuously
C
Stops data output by SIR command.
QM
Outputs the data during measurement. (In other mode, QM can not use.)
START Same
as
the
START
key
STOP Same
as
the
STOP
key
RESET Same
as
the
RESET
key
ENTER Same
as
the
ENTER
key
SELECT Same
as
the
SELECT
key
DOWN
Same as the
key
UP
Same as the
key
PROGRAM Same
as
the
PROGRAM
key
Header Moisture content
Unit
Terminator
160°C at sample pan
Header Moisture content
Unit
Terminator
160°C at sample pan
Header Moisture content
Unit
Terminator
160°C at sample pan