KEYENCE BL-N90 Series - Manual (Page 56)

4-2
4
Pr
o
g
ra
m
4-1 Using the Program Barcode Menu
Read the program barcode menu to make changes to the program for the BL-N90 Series.
Configuring the Program
Use steps 1 to 3 as shown below to change the program.
Steps 1 and 3 (reading the Start/End Program barcode) can be omitted when configuring
settings other than the ones listed below.
• Laser off time setting ( page 4-13)
• Limit read digits ( page 4-18)
Note
Before configuring the program, complete steps 1 to 5 of "Initial Setup" ( page 2-2)
and check that wireless communication is established between the BL-N90 and the
communication unit (the blue LED is lit on the communication unit).
1 Read the "Start/End Program" barcode.
2 Read all of the program barcodes for setting that you want to change.
3 To save the settings, read the "Start/End Program" barcode.
Note
• During program mode, an error alarm sounds when a barcode other a program
barcode is read. Do not read a barcode other than a program barcode during
program mode.
• If a program barcode is not read for about one minute during program mode, a
buzzer sounds three times , the set information is lost, and program mode
ends. Restart the settings from the beginning to make changes.
3
3
3