KEYENCE SL-C Series - Manual (Page 34)

Chapter 2 Installation and Assembly
2-12
2
English ENGLISH
3. Tighten the bolt with the hexagon socket enough to hold them in place.
4. Tighten the bolts with the hexagon sockets with a mounting torque of 7 N•m while holding the
beveled area at the end of the bar (10 mm (0.39") diagonally) in place with a wrench.
5. Then use M3 ( r=7) screws to attach the bar brackets to the SL-C unit. Make sure the bar is not
skewed.
6. Use M3 ( r=10) screws with standard mounting brackets A, B, and C, as well as with L-shaped
mounting brackets.
7. Install 1 intermediate support bracket (included) onto protection bars when the bar length is longer
than that of OP-42357 (SL-C36H/SL-C18L). For information about how to install the intermediate
support bracket, see "2-8 E-to-E mounting bracket assembly and installation". For information about
the position at which the bracket should be installed,
see “1-4 Dimensional Drawings (Dimensions
by model) (page 1-7)”.
5
3
4
[Bottom]
[TOP] * The bar should be secured
to the bottom in the same way.
Recommended tightening torque:
0.7 N•m
Recommended tightening torque:
7 N•m
* Non standard mounting bracket present or L-shaped mounting bracket: screw length is M3 ( r=7).
Standard mounting bracket present or L-shaped mounting bracket: screw length is M3 ( r=10).
Number of required protection bar intermediate support brackets and E-to-E mounting brackets
Protection bar Applicable Model
No. of Bar support brackets
Intermediate
Model to protection bar support bracket
OP-42350 SL-C08H None None
OP-42351 SL-C12H None None
OP-42352 SL-C16H/SL-C08L None None
OP-42353 SL-C20H/SL-C10L None None
OP-42354 SL-C24H/SL-C12L None None
OP-42355 SL-C28H/SL-C14L 2 None
OP-42356 SL-C32H/SL-C16L 2 None
OP-42357 SL-C36H/SL-C18L 2 1
OP-42358 SL-C40H/SL-C20L 2 1
OP-42359 SL-C44H/SL-C22L 2 1
OP-42360 SL-C48H/SL-C24L 2 1
OP-42361 SL-C52H/SL-C26L 2 1
OP-42362 SL-C56H/SL-C28L 2 1
OP-42363 SL-C60H/SL-C30L 2 1
OP-42364 SL-C64H/SL-C32L 2 1
WARNING
When mounting the SL-C to a machine, use the mounting method shown in this
instruction manual, and make sure the SL-C is securely mounted.
Insufficiently tightened screws or incorrect mounting of the SL-C may cause a
serious accident, such as serious injury or death of the machine operator.
When mounting the models SL-C36H through SL-C64H or SL-C18L through SL-
C32L, be sure to use the intermediate support bracket provided with the accesso-
ries and mount it in the correct location for the SL-C Series.