KEYENCE SL-C Series - Manual (Page 31)

Chapter 2 Installation and Assembly
2-9
2
ENGLISH
2. Thin type mounting bracket A (OP-51698) tightenig methods
Secure the mounting bracket using three screws as shown below.
1
M3 (r=7)
2
3. E-to-E mounting bracket (OP-42370) assembly and tightenig methods
1. Mount bracket A on the SL-C (Use a recommended tightening torque of 0.7 N•m).
2. Fix bracket B to bracket A using two screws (Use a recommended tightening torque of 0.7 N•m).
3. At the opposite side of bracket A from the side where bracket B is mounted, slide in bracket C,
determine its angle, and fix it using a screw (Use a recommended tightening torque of 0.7 N•m).
2
1
5
3
4
Mounting
bracket B
Mounting
bracket A
Mounting
bracket C
M3(r=7)
M4(r=12)
4. L-shaped mounting bracket (OP-42371) assembly and mounting methods
Secure the L-shaped mounting bracket using three screws as shown below.
M3 flathead
(small head) (r=5)
L-shaped mounting bracket Installation examples of L-shaped mounting bracket
Top Bottom
3
2
1
Beam axis surface
Beam axis
surface
Beam axis
surface
Beam axis
surface
Beam axis
surface
Beam axis surface
The sensor can be rotated to the left and right
when these 2 screws (M3:R=2.5) are loos-
ened, allowing adjustment of the beam axis.
(Use a recommended tightening torque of 0.7
N•m for these screws.)