KEYENCE SL-C Series - Manual (Page 33)

Chapter 2 Installation and Assembly
2-11
2
ENGLISH
A mounting torque of 0.7 N•m or less should be used when attaching brackets to the SL-C (M3
screws).
The bar mounting torque should be 7 N•m or less (5 mm (0.2") diagonal M6 hexagonal bolts).
2. Installation procedure
1. Install the protection bar as described in steps ➀ to ➁.
2. Install the mounting bracket when the bar length is longer than that of OP-42355 (SL-C28H/SL-
C14L), install these in two location. See “1-4 Dimensional drawings (Dimensions by model) ( ➮ page
1-7)” for information about the positions where protection bars should be installed.
1
2
3
M3(r=7)
Recommended tightening
torque: 7 N•m
3.
1. Tighten the bolt with the hexagon socket enough to hold them in place.
2. Attach the bar to the bar support brackets.
[Top]
1
2
• Intermediate support
bracket
Bolt with hexagon socket
(Diagonally: 5mm (0.2"))
2 bolts
2 brackets used when the
bar length is longer than
that of OP-42355 (SL-
C28H/SL-C14L only)
• Screws M3 X L7 6 to 10 screws
M3 X L10 6 screws
2 brackets
• Bar support bracket
1 bracket used when
the bar length is
longer than that of
OP-42357 (SL-C36H/
SL-C18L only)
2-3-3 Protection Bar Installation
This section describes the procedure used to install the protection bar. (The protect bar cannot be used
combined with the SL-C**F and thin type mounting bracket (OP-51698).)
1. Part names
• Bar 1 bar
• Bar bracket A