KEYENCE LS-Navigator User Manual

Page 49

5-17

LS-Navigator-M-NO5-E

5-7 Setting RS-232C Communication Conditions

Check that the [D-MODE] setting on the
controller is [NORMAL], and then click on
the [Next] button on the [Setting Wizard].

After checking all of the messages, click on
the [End] button.
The display returns to the [Communication
settings] window. Use the following procedure to
check the [D-MODE] setting for the controller.

■ For the LS-7600/7500 series
Press and hold the [ESC] button for at least three
seconds while in [Setting] menu of the controller.
Check the [D-MODE] setting in the
[Environment Setting] menu that appears.

■ For the LS-7000 series
Press the [FUNC] key four times in the [RS-232C
display] menu for the controller. Press the [

▲]

and [

▼] keys to select [D-MODE] and check the

setting.

Switch the controller to [Measurement]
mode and click on the [Comm check]
button in the [Communication settings]
dialog for LS-Navigator.
The “Connection status OK” message appears
and settings are completed.

For the LS-7600 series

For the LS-7000 series