KEYENCE LS-Navigator - Manual (Page 44)

5
LS-Navigator-M-NO5-E 5-12
5-7
Setting RS-232C Communication Conditions
This section describes how to set the same RS-232C communication conditions on LS-
Navigator as used on the connected controller.
1
The software can check the following RS-
232C communication conditions for the
controller environment settings.
•
Baud rate ([BAUDRATE])
• Stop bit ([STOPBIT])
• Data length ([D-LENGTH])
• Data mode ([D-MODE])
• Data send mode ([D-SEND])
Use the following procedure to check the RS-
232C communication conditions.
For the LS-7600/7500 series
Press and hold the [ESCAPE] button while in
[Setting] mode for at least three seconds, and then
check the settings in the [Environment settings]
menu that appears.
For more details, see “Environment Settings” in
the “User’s Manual” for the LS-7600/7500 series.
For the LS-7000 series
Press the [FUNC] key once during [Program]
view, and then check the settings in the [RS-
232C] view that appears.
For more details, see “RS-232C” in the “User’s
Manual” for the LS-7000 series.
2
Select [Communication settings] from the
[Settings] menu.
Or click on the [Com settings] icon on the
tool bar.
The [Communication settings] dialog appears.
2
2