Hangar 9 1/4-Scale J-3 Cub ARF - Manual (Page 9)

9
 .  .  .Step 5
Apply.thin.CA.to.the.top.and.bottom.of.each.of.the.three.
hinges..Make.sure.to.saturate.each.hinge.so.there.is.
enough.CA.to.wick.into.the.hinge.and.bond.with.the.
surrounding.wood.
Note:.Do.not.use.CA.accelerator.on.the.
hinges..The.CA.must.be.allowed.to.wick.
fully.into.the.hinge.to.provide.the.best.bond.
between.the.hinge.and.the.surrounding.wood.
 .  .  .Step 6
Allow.the.CA.plenty.of.time.to.cure..Once.cured,.pull.on.
the.elevator.and.stabilizer.to.make.sure.the.hinges.are.
fully.glued.into.position.
 .  .  .Step 7
Flex.the.elevator.up.and.down.a.number.of.times.to.break.
in.the.hinges..
Hinging the Control Surfaces